Stamped Concrete in Warwick, NY in Orange County

This project took place in phases over several years.  The first phase was the front sidewalk which was completed in November of 2019.  We were back in 2020 to begin work on the largest phase of this project which involved the patio, resurfacing the steps, resurfacing the screened in patio, constructing the fire pit, seatwall for around the fire pit, and grill area.

Later phases included an apron in front of the detached garage, enclosure for the hot tub, pillars at the end of the driveway, and curtain drain around the patio to enhance the drainage.  The firepit and the seatwall were built with the Spider Tie wall system which helped to create a solid structure while giving us the ability to work with the curved shapes.  The vertical areas on the seat wall and the fire pit are covered with a hand carved concrete, shaped and textured to look like a fieldstone.  The grill area was built out of block, then was carved with the same process to match the fire pit and seatwall.  For the hot tub area, a 5” thick slab was poured and then a block wall was built on 3 sides.  The back was left open to slide the hot tub in and also be able to access the mechanicals.  A stamped concrete cap was poured on the wall to match the seatwall, firepit, and countertops.  The vertical areas were then carved to match the fieldstone look. 

For the driveway pillars, a footing was dug and poured below the frost line and then concrete block was run up.  A stamped concrete cap was poured to replicate the look of a limestone, and then the carved concrete was applied.